Reply To: Cube Rotate

[drholz]

In that case, the axis value would just be an on or off value of 1 or 0?
Any other number entered would just be interpreted as a value for that axis.
That would make sense as I can enter 100 or 1 in the X input and it spins the same speed until
I increase the angle input amount.
Now…just need to figure out where that set ‘time.delta time’ node is hiding…
I found a set ‘time.set maximum delta time’ node and it hooks up, but don’t really notice any change
when I input a value on that…
Thanks for your help.